Setting up at Maker Faire Bay Area 2014

PlotterBot - packed up and ready to go

PlotterBot – packed up and ready to go

One of the things I appreciate most about the design of my PlotterBot is that it is extremely modular and portable.  All of the parts have been designed so that the entire robot can be assembled and disassembled with a single 3mm hex wrench.  Pictured above is everything I need to setup the robot and spend all weekend drawing – the tools, hardware, replacement parts, extra tape, paper, and pens.1  Best of all, all this stuff fits neatly into my car’s trunk.  The robot underneath in the “well” of the truck, with the large pieces of plywood on top.

I took pictures from the same standpoint as I set up the booth.

This slideshow requires JavaScript.

Or, if you prefer, here’s an animated GIF of the setup.  🙂

Maker Faire Bay Area 2014 Setup

Maker Faire Bay Area 2014 Setup

  1. If only I had remembered the metric ruler! []
Posted in Maker Faire Tagged with: , , , ,
0 comments on “Setting up at Maker Faire Bay Area 2014
1 Pings/Trackbacks for "Setting up at Maker Faire Bay Area 2014"
  1. […] Since my entire booth was basically a wooden box that unpacked into a robot that made decorations for my booth, set up was rather easy. […]

Leave a Reply

Your email address will not be published. Required fields are marked *

*

Drawing Robot Newsletter

No spam. Just drawing robots.